TECH IMPRO AUTOMATION SOLUTION SDN BHD
7263, 1st Floor, Lorong Chempa, 12200 Butterworth, Penang, Malaysia.
+6012-466 1514

SIMEX SCK-11

SIMEX SCK-11 Inclinometers SIMEX
Quantity
Add Quotation


  • inclinometer with two orthogonal axes
  • high accuracy, temperature compensated
  • high resistance to vibrations
  • precision internal accelerometer
Description

The dual axis inclinometer module SCK-11 was designed to stationary measurements of inclinations of two orthogonal axes in relation to earth. Recommended range of measured angles maintains from -70 to +70 deg. While measuring in range -20 to +20 deg. range, the precision is better than 0.1 deg. in both axes. If measured angles exceeds range ±75 deg. (in relation to earth) the measurement error can be higher 3 deg. (at both ends of range). Due storing of new scaling values to internal registers it is possible to change measurement unit and resolution to any other linear. Build in offset registers allows user to measure relative angles and self zeroing after mounting.
In addition to two registers containing information about SCK-11 installation plane angle relative to the earth (two angles with the offset function), threre are available additional two records containing information on the accelerations in the same axes, what makes measurement of transducer movement more precision. Indications of these records are expressed in 1/1000 of earth gravity, which corresponds to the reading equal to 1000 when inclination of sensor equals 90 deg. in relation to earth. Additional temperature measurement circuit allows to check temperature of internal accelerometer and  compensate the measurements. Internal temperature can be read by user as third measurement channel. Substantial aluminium case with high IP rating, wide operation temp. range and temperature compensation circuit allows to use SCK-11 outside of buildings, with hard environment conditions (containers, platforms, outriggers, jibs etc.). The device should not be used while strong vibrations occurs and must not be used for security systems.
SCK-11 is equipped with RS-485 communication interface with Modbus RTU protocol, allowing direct readings of measurements and full configuration of the device.

Specification
Power supply
10...36V DC
Measurement range
±70 deg. in relation to earth
Accuracy
±0,5%
±0,2%
±0,05%
Operating temperature
-30…+60°C
Communication Interface
RS-485 / Modbus RTU
Protection class
IP 67
Case material
aluminium
Case dimensions
75 x 80 x 57 mm

Please leave your enquiry here, we will reply as soon as possible.
Name*  
Company Name  
Product Interested  
Quantity  
Email*  
Contact No.*  
Attachment  
*only support gif, jpeg, jpg, png, pdf
Messages*  

You have 0 items in you cart. Would you like to checkout now?
0 items
Switch to Mobile Version