- Allen-Bradley
- ASHCROFT
- New & Featured Products - HPS high-purity pressure gauge with Reed Switch
- New & Featured Products - S1 Pressure Transducer
- New & Featured Products - ZT12 High Purity Pressure Transmitter
- New & Featured Products - ZX12 High Purity Pressure Transmitter
- Pressure Instruments - Accessories
- Pressure Instruments - Diaphragm Seals-Isolators
- Pressure Instruments - Pressure Gauges
- Pressure Instruments - Pressure Sensors (Transducers/Transmitters)
- Pressure Instruments - Pressure Switches
- Pressure Instruments - SMART Transmitter Assemblies
- Temperature Instruments - MultiPoint Temperature Sensors
- Temperature Instruments - OEM Temperature Sensors
- Temperature Instruments - RTDs
- Temperature Instruments - Temperature Switches
- Temperature Instruments - Thermocouples
- Temperature Instruments - Thermometers
- Temperature Instruments - Thermowells
- Test Instruments - Calibrators
- Test Instruments - Hand Pumps-Controllers
- Test Instruments - Hydraulic Testers
- Test Instruments - Test Gauges
- Cosel
- Euromag
- eYc
- Finetek
- Huba Control
- Koyo
- Maxwell
- MEKKO
- Prokits
- 3C Product Repair Tools
- Aid Tools
- Alignment Tools & Screwdrivers
- Ceramic Driver
- Crimpers
- Cutter
- Drill Bits
- Driver Set
- Electrical Pliers
- Fiber Optics
- Hex Key Wrenches
- Hex Nut Drivers
- Knives & Scissors
- Miscellaneous
- Plier
- Power Tools
- Precision Tweezers
- Punch Down Tools
- Socket Wrenches
- Soldering & Desoldering
- Storage Box
- Strippers
- Test Instruments
- VDE Insulation Tools
- Setra
- Siemens
- SIMEX
- Sondar
- SURE INSTRUMENTS
- Suto
- Tsuruga
- VAISALA
- VE-PURE
- WELTEM
- Winters Instruments
TECH IMPRO AUTOMATION SOLUTION SDN BHD
7263, 1st Floor, Lorong Chempa, 12200 Butterworth, Penang, Malaysia.
+6012-466 1514
TSURUGA MODEL 8508
Previous | 1 / 2 | Next |
- ¡ö High speed withstand voltage test (50ms)
- ¡ö Leakage current is measured by Peak-hold method
- ¡ö Available with Micro-short check function
- ¡ö Available with 8 patterns of test condition memories
- ¡ö Interface RS-232C is included in standard product
- ¡ö For standard model, visit here (MODEL 8507)
Specification
Test Voltage | |
---|---|
Applied voltage | AC 0.05 to 6.00 kV¡¡(Frequency 50/60 Hz Switchable) |
Output capacity |
6 VA (0.6 kV, 10 mA) Maximum current output: within 60s during continuous test |
Waveform | Sine wave (Rate of distortion: Less than 5%, No-load) |
Voltage regulation | Less than 10% (No-load→Maximum load) |
Voltage application method | Zero-cross Start / End |
Voltage setting | Digital setting (resolution: 0.01kV) |
Voltage Measurement | |
Rectification method | Average rectified effective value display |
Measurement range | 0 to 600V (resolution: 1V) |
Measurement accuracy | +/- (1.5% of rdg. +20V) |
Current Measurement | |
Rectification method | Peak value display |
Measurement range | 0.00 to 15.00mA (resolution: 0.01mA) |
Measurement accuracy | +/- (2% of rdg. +0.05mA) |
Judgement of Test Result | |
Judgement method |
Upper limit: Comparison of peak values with analog and digital comparator Lower limit: Digital comparator (Comparison when time is up) |
Setting range |
Upper limit: 0.01 to 15.00 mA Lower limit: 0.01 to 15.00 mA / OFF |
Judgment conditions |
Upper limit setting£¾Leakage current£¾Lower limit setting・・・GOOD Upper limit setting¨QLeakage current・・・・・・・・HIGH NG Lower limit setting¨RLeakage current・・・・・・・・LOW NG |
Test time | |
Setting range | 2 cycles to 60s (resolution: 1cycle) |
Power supply | AC100 to 240V, 50/60Hz (Allowable voltage range: AC90 to 250V) |
---|---|
Power consumption |
Approx. 17 VA (during no load) Approx. 65 VA (during max. rated load) |
Operating environment | 0 to 40¡æ, 20 to 80%RH (No condensation) |
Withstand voltage | Power supply terminal £ External case: AC 1350 V, 1 min. |
Dimension | 260(W) x 246(D) x 110(H) mm (excluding buttons and legs) |
Weight | Approx. 4.5 kg |
Accessories |
High voltage cable 2m ・・・1piece Low voltage cable 2m ・・・1piece Earth wire 3m ・・・1piece Power code 2.5m ・・・1piece REMOTE I/O plug ・・・1piece Operating manual ・・・1part |
Data Output
RS-232C…… Test condition setting & Test result output | |
---|---|
Connector | D-sub 9 pin |
Transmission system | Start-stop synchronization Full duplex |
Transmission rate |
9600, 19200, 38400, 115200 bps £¨Factory setting: 9600bps£© |
Data bit length | 8 bit |
Parity bit |
None, even number, odd number £¨Factory setting: None£© |
Application
Multipin connector, multi-core harness etc.